Temperature of the Fixing Assembly did not reach a certain temperature within the specified period of time.
Remedy:
1. Check the connector between the Fixing Assembly and the Engine Controller PCB. 2. Replace the Fixing Assembly. 3. Replace the Engine Controller PCB.
Error code:
E001 0000
Description:
Abnormal high temperature of Fixing Assembly
Causes:
It was detected that the temperature of the Fixing Assembly was abnormally high.
Remedy:
1. Check the connector between the Fixing Assembly and the Engine Controller PCB. 2. Replace the Fixing Assembly. 3. Replace the Engine Controller PCB.
Error code:
E003 0000
Description:
Abnormal low temperature of Fixing Assembly
Causes:
It was detected that the temperature of the Fixing Assembly was abnormally low.
Remedy:
1. Check the connector between the Fixing Assembly and the Engine Controller PCB. 2. Replace the Fixing Assembly. 3. Replace the Engine Controller PCB.
Error code:
E004 0000
Description:
Error in fixing power supply drive circuit
Causes:
Failed to detect the zero cross signal for the specified period of time or more.
Remedy:
1. Check the connection of connector between the Fixing Assembly and the Engine Controller PCB. 2. Replace the Fixing Assembly. 3. Replace the Engine Controller PCB.
Error code:
E100 0001
Description:
Error in scanner motor/laser unit/BD
Causes:
Failure in Magenta optical unit
Remedy:
1.Check connectors of laser scanner unit and DC controller PCB 2.Replace laser scanner units 3.Replace DC controller PCBs
Error code:
E196 2000
Description:
Main Controller PCB reading/writing error
Causes:
Error in reading/writing of setting values storage area in the Main Controller PCB
Remedy:
1. Install the set of the controller firmware. 2. Replace the Main Controller PCB.
Error code:
E225 0001
Description:
Light intensity of the CIS Unit below the reference level
Causes:
When the light intensity is below the reference level at shading
Remedy:
1. Disconnect and then connect the Flexible Cable. 2. Replace the Flexible Cable. 3. Replace the CIS Unit. 4. Replace the Main Controller PCB (PCB2).
Error code:
E225 0002
Description:
Insufficient lamp light intensity (The light intensity is partially at the reference level or below.)
Remedy:
When the same error repeatedly occurs although the power is turned OFF and then ON for several times, execute the following remedies. (1) Check the connection between the Main Controller PCB and the CIS Unit. (J2) (2) Replace CIS Unit.
Error code:
E736 0000
Description:
Communication error with CCU/modem
Causes:
Communication error with CCU/modem. NCU PCB type error.
Remedy:
1. Install the set of the controller firmware. 2. Replace the NCU PCB. 3. Replace the Main Controller PCB.
Error code:
E744 0002
Description:
Language file size error
Causes:
The size of the language file exceeded the upper limit.
Remedy:
Install the set of the controller firmware.
Error code:
E744 4000
Description:
Engine ID error
Causes:
Invalid engine connection was detected.
Remedy:
1. Turn OFF and then ON the main power. 2. Check the Engine Controller PCB. 3. Install the Engine Controller PCB. 4. Install the set of the controller firmware. 5. Check the model code. (When the model code and the engine code are mismatched, E744-4000 occurs.)